Automated Learning Process./ Activating Code; Remote Control - Craftmade Pill PIL52 Guide D'installation

10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
Remove battery cover on back side of remote control
transmitter. Install one 12-volt battery (included).
Since this fan comes with an LED light kit, the dimmer
switch (labeled ON and D) has been pre-set to the
"ON" position (ON). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (D).
Restore electrical power. Turn power off again for at
least 5 seconds and then turn power back on. Within
60 seconds of restoring the power, press and hold the
fan SET button for 5 seconds or until light blinks
twice. Then replace the battery cover.
NOTE: Battery is not rechargeable. Remove batteries
with low or no charge and dispose of properly.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK." - When disposing
of household alkaline batteries, it is best to check with
your local and state recycling or household hazardous
waste coordinators concerning the specifics of the
program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or
1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
WARNING: Non-rechargeable batteries are not to be
recharged; Do not mix different types of batteries
such as alkaline, carbon-zinc, or rechargeable
batteries; Do not mix old and new batteries; Batteries
are to be inserted with the correct polarity; Exhausted
batteries are to be removed from the product.

REMOTE CONTROL

dimmer
switch
page 9
(back)
SET
I I I
IV
V
I I
VI
I
REMOTE CONTROL
(front)
battery
battery
cover