Led Light Kit Assembly - Craftmade Pill PIL52 Guide D'installation

9. LED Light Kit Assembly.

Remove 1 screw from motor plate on underside of
motor housing
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come
through holes in midde of fitter plate. Twist fitter
plate to lock. Re-insert screw that was just
motor plate
removed and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 1 screw from underside of fitter plate and fitter plate
partially loosen the other 2 screws.
molex
connections
Connect WHITE wire from LED light kit to WHITE
wire from motor housing. Connect BLACK wire
from LED light kit to BLACK (or BLUE) wire from
LED light kit
motor housing. Be sure that molex connections
nodules
snap together completely.
grooves
Carefully arrange wiring within LED light kit. Align
slotted holes in LED light kit with loosened screws
on fitter plate. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
shade
3 screws securely.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place.
Pull down VERY GENTLY on shade to make sure that
shade is secure.
page 8