Lavor KLS-LS Classic Manuel D'instructions page 22

EN
MAIN FEATURES AND TECHNICAL SPECIFICATIONS
Fuse
Minimum inlet water temperature
Minimum inlet water flow
Maximum inlet water pressure
Minimum inlet water pressure
Recoil of cleaner gun
Sound pressure level - Uncertainty (*)
Sound power level
Operator arm vibrations - Uncertainty (*)
Lenght x width x height
Detergent tank capacity
(*) Measurements taken in compliance with EN 60335-2-79
All features and technical specifications are only indications. The Manufacturer reserves the right to modify the appliance as it
deems necessary.
For other technical data, refer to the identification plate on the machine (see data interpretation on page 15 of this
manual).
USAGE
WARNING: First of all read the Safety War-
nings and then this Specific Manual.
> PUT INTO SERVICE
See fig. A
> STARTING UP
See fig. B
> HIGH PRESSURE LANCE
See fig. D
> DETERGENT SUCTION
See fig. E
> HIGH PRESSURE HOSE
See fig. F
> WATER SUPPLY
Water supply collection
22
KLS 1400/LS 1400 KLS 1600/LS 1600 KLS 1680/LS 1680
900 l/h - 15 l/min - 172 US gph
1 MPa - 10 bar - 145 psi
0,1 MPa - 1 bar - 14,5 psi
76 dB(A)
WARNING (symbol): machine not suitable
for connection to the potable water mains.
The cleaner can only be connected to the
water mains if the water mains is separated by
a backflow preventer.
Make sure that the hose is at least Ø 13mm-1/2
inch and that it is reinforced.
WARNING: Water that has flown through
backflow preventers is considered to be non-
potable.
IMPORTANT: Only clean or filtered water should
be used for intake. The delivery of the water
intake tap should be equal to the double of the
maximum pump range.
Place the cleaner as close to the water supply
system as possible.
Failure to comply with the above conditions
causes serious mechanical damage to the
pump and the loss of warranty cover.
Water supply from the potable water mains
16 A
5 °C - 41 °F
12 N
+/- 1,5 dB(A)
90 dB(A)
1,5 m/s² - 0,5 m/ s²
300 x 300 h 840 mm
0,7 l - 0,18 US gal