Helvi Explorer 120 Manuel D'instructions page 12

Export charging data on USB stick:
This function allows you to retrieve the charge history and data on a USB key, in order to be able to use
them on a spreadsheet or other.
1 Enter the "Export DATA" submenu
2 Confirm the recording of the charging data.
3 The charger will then copy the charging data to the USB stick as files, « .CSV »
Custom configuration
List of modes and profiles available for customization:
CHARGE MODE
Charge type: Charge
profiles
normal
AGM
water
Easy
Pb-CHARGE
boost
recovery+
LFP/
LiFePO4
Li-ion std
Li-CHARGE
LFP cell+
Li-ion
cell+
water
TRACTION
gel
POWER MODES
Showroom
DIAG+
CHANGE BAT.
POWER SUPPLY
12
Charging
voltage
2.40 V/cell Charging profile for lead batteries of the types Gel, MF, EFB, SLA...
Charging profile for most AGM lead-acid batteries including START and
STOP .
2.45 V/cell
However, some AGM batteries require a lower voltage charge (Normal
profile). Check the battery manual if in doubt.
2.45 V/cell Charging profile for open liquid-type lead-acid batteries with plug.
Charging profile dedicated to lead batteries that automatically adapts
the charging current according to the size of the battery.However, for
2.40 V/cell
maximum charge optimization, it is recommended, when possible, to
use normal, AGM or liquid charge curves.
Maximum current charge for lead-acid battery. This type of charge is
ultra-fast.
2.42 V/cell
Warning : this type of charge must remain occasional in order to preserve
battery life.
Charging profile for the recovery of severely damaged lead batteries.
2.40-2.50 It is essential to recover the battery outside the vehicle to avoid
V/cell damaging the vehicle electronics and in a well ventilated area.
Caution: Recovery voltage up to 4.0 V/cell.
3.60 V/cell Charging profile for Lithium batteries type LFP (Lithium Ferro Phosphate)
4.20 V/cell Charging profile for standard lithium-ion batteries based on Manganese
or Cobalt (NMC, LCO, LMO, MCO...)
Charging profile dedicated to LFP (Lithium Ferro Phosphate) type li-
3.60 V/cell
thium-ion cells with selection of the number of cells in series to be charged.
Charging profile dedicated to standard lithium-ion cells based on
4.20 V/cell Manganese or Cobalt (NMC, LCO, LMO, MCO...) with selection of the
number of cells in series to be charged.
2.42 V/cell Charging profile dedicated to open lead traction batteries for forklift
trucks.
2.35 V/cell Charging profile dedicated to gel-type traction batteries for forklift trucks.
Maintains the battery's state of charge and supplies power when using the electrical
consumers of a demonstration vehicle.
Supplies energy requirements during the vehicle diagnostic work.
Allows to keep the vehicle power supply during battery replacement, in order to preserve
the memory of the vehicle's ECUs.
Allows the charger to be used as an adjustable stabilized power supply with high power.
The voltage to be regulated and the current limitation are fully adjustable.
Export DATA
Continue?
Yes
Loading