Operation - ArmorAll AA20BW Manuel D'utilisation

NOTICE:
Before using the blower, read all safety precautions and follow the instructions in the
Battery Pack and Charger sections. The battery pack is not fully charged when it is purchased.
INSTALLING & REMOVING BATTERY PACK
2
1. To install the battery pack, firmly grasp the blower and align the tongue on the battery pack with
the groove on the tool housing and slide it into place. Insert it all the way until it locks in place
with a click (Fig. 2).
2. To remove the battery pack, slide it from the tool while pressing the release button on the front
of the pack (Fig. 3).
OPERATING THE BLOWER
1. Make sure the battery is correctly installed.
2. To turn on the blower, press and release the trigger switch (Fig. 4).
3. To turn off the blower, press and release the trigger switch again.
AIR VOLUME ADJUSTMENT DIAL
4
The air volume of the blower can be adjusted by turning the air volume adjustment dial found
on top of the handle. The blower has 6 air volume settings ranging from 1 (low speed) to 6 (high
speed) (Fig. 4).
CAUTION:
charge, rest the tool for at least 15 minutes before inserting a new battery.

OPERATION

3
Air volume adjustment dial
Trigger switch
If the tool is operated continuously until the battery pack has run out of
8