SystemAir TControl EASY 3S Notice D'installation page 9

Display fan speed:
Parameter value
Changer No, key
Exit setting key
No. Name of parameter
1 Temp. correction
2 Key-lock
3 not used
4 Temp. upper limit
5 Temp. lower limit
6 LCD backlight
7 Fan operation setting
8 Fan coil selective
All parameters are stored within an EEPROM ensuring no data loss if the Thermostat is powered off.
Hysteresis: 1 K + 1 minute switching delay
Low
Medium
High
Auto
Parameter definition
Range ±10 °C
0 – unlocked
1 - lock on/off
2 - lock Mode
3 - lock fan speed
4 - lock temp setting
5 - lock all the keystrokes
Range: +1..+50 °C
Range: +1..+50 °C
0 - without backlight
1 - with backlight
0 – Independent
1 - Dependent
2 – 2-pipe system
4 – 4-pipe system
Parameter No.
Value decrease key
Value increase key
Default
0
0
30 °C
16 °C
1
0
2
TControl EASY 3S 7