Preparing For Use - Jacuzzi andros Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

display
pump
spotlight
Display and adjust temperature
Function parameters
Prolonged sun exposure could damage the material of
which is made the spa shell, due to its capacity to absorb
heat (dark colours in particular). Don't leave the spa to sun
exposure without adequate protection when not in use
(cover thermal, gazebo, etc.).
Any damage arising by not following these warnings are
not covered by the guarantee.
I

PREPARING FOR USE

CAUTION
The preliminary checks and any system ad-
justments must be performed by qualified au-
thorised personnel, under their own respon-
sibility.
Instructions are provided in the second part
of this manual.
The user must appoint a qualified person able to manage
and run the system, in particular as regards the following op-
erations:
Filling the spa with water.
The optimum level is obtained when the water reaches the
level mark on the skimmer (
Verification of water quality, chemical control of pH
and water sanitation.
These checks must be performed frequently to guarantee
long-term water quality, especially if the spa is used by
several persons.
i
2, detail A).
Make sure that ALL the operations described in the
section "Operating instructions for the system user Gen-
eral Warnings Initial Start- up" have been carried out.
Turn on the system's main switch.
CAUTION
Do not power the system if the spa is not filled
with water up to the normal filling level, as this
may damage the pump.
Failure to observe this warning will immediate-
ly invalidate the warranty.
I
LIMITATION OF ELECTRICAL CONSUMPTION
If there is not enough electrical energy and you decide to ac-
tivate the consumption limiter, the system software must be
configured for proper operation of the spa:
Press and hold the "Light"
til the message"cFn" appears.
If necessary, use the "Up"
scroll the menu until you see "cFn". Press the "Light"
gain to confirm the option.
Now insert the password 123 as follows:
- use the "Up"
and/or "Down"
number.
NOTE: keep the button pressed down until you reach the de-
sired value.
- confirm the selection by pressing the "Light"
26
Pump operation LED
Spotlight operation LED
Filtering cycle LED
Heater operation LED
Temperature adjustment LED
key for about 12 seconds, un-
and/or "Down"
keys to
keys to insert the first
key.
i
7
key a-

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

OxiaKios friendly

Table des Matières