Troubleshooting - Kenwood AS-IP70 Mode D'emploi

Troubleshooting

A trouble with the unit does not always mean a failure. In case of a trouble, check the following lists before calling for service.
Amplifi er/Speakers
Symptom
Audio is not output.
Clock is not displayed.
Tuner
Symptom
Radio stations cannot be received.
Noise interferes.
Preset stations cannot be displayed.
USB/SD/iPod/iPhone
Symptom
Music, photo or video is not output even
after an SD card/USB fl ash memory/iPod/
iPhone is connected.
How to Reset the Unit
Symptom
The unit malfunctions (impossibility of
control, erroneous display, etc.)
AS-IP70
Remedy
• Connect the cords properly.
• Increase the volume setting.
• Perform clock setting.
Remedy
• Connect the antennas.
• Set the correct radio reception band (receiving mode).
• Tune the frequency of the desired station.
• Install the antenna at a distance from the road.
• Turn off the electrical equipment used in proximity of this unit.
• Use the unit at a distance from a TV set.
• Perform Auto Preset of radio stations again.
• Perform Manual Preset of the radio stations of receivable frequencies.
Remedy
• Connect the SD card/USB fl ash memory/iPod/iPhone properly.
• Connect the USB cable properly.
• Confi rm that the USB Mass Storage Class-compatible digital audio player
is turned on.
Check Point/Treatment
This unit may malfunction due to disconnection of a cord while the unit is on or to other
extraneous factors. If this happens, reset the unit with the following steps.
1
Remove the external device such as an SD card, USB device or iPod/iPhone from the unit.
2
Disconnect the AC adapter, wait for some tens of seconds and then connect the AC adapter
again.
26
Page
7
8
10
Page
7
18
18
—
18
19
Page
9
9
—