Grohe Blue 40 554 Mode D'emploi page 10

• The cooler/carbonator must be
connected to a permanent power
supply.
• At the installation location, the
cooler/carbonator, CO
and filter system must be
protected from mechanical
damage, heat and direct sunlight.
• Do not install near heat sources or
an open fire.
• The cooler/carbonator must be
placed in an upright position.
• The cooler/carbonator must not
be opened.
• Installation of the fitting and cooler/
carbonator with filter cartridge is
only permitted in frost-free rooms.
• The cooler/carbonator is only
suitable for indoor use.
• Adequate ventilation must be
ensured. If necessary, provide
ventilation grilles in the cover of the
lower cabinet.
7
• Following installation, the cooler/
carbonator must be cleaned
before first use.
Note: The cleaning kit (prod. no.:
40 434 001) and the
cylinder
2
accompanying adaptor (prod.
no.: 40 694 000) can be ordered at
www.shop.grohe.com.
• Use only genuine replacement
parts and accessories. The use
of other parts will result in voiding
of the warranty and the CE
identification, and could lead to
injuries.
• Only use the supplied hoses
provided upon delivery.
Do not reuse old hoses.
• The cooler/carbonator works with
environmentally-friendly
refrigerant.
Electrical installation work
must only be performed by a
qualified electrician. This work
must be carried out in
accordance with the
regulations according to
IEC 60364-7-701
(corresponding to VDE 0100
Part 701) as well as all national
and local regulations.