Cleaning And Maintenance - Furrion CHILL FACR13HESA Serie Manuel De L'utilisateur

How to prevent frosting or icing in the air
conditioner?

CLEANING AND MAINTENANCE

A blocked filter will impair the cooling and heating performance
of the unit significantly.
The filter must be cleaned periodically to ensure that it does
not become clogged with dust and other particles. The state of
the filter can be ascertained from its appearance. If it appears
dirty or clogged then it should be cleaned.
WARNING
Airborne particles can pose a health risk, particularly to
young children and the elderly. Ensure that filters are cleaned
in a safe and well ventilated area.
To Clean the Filter
The filter should be cleaned every four weeks or more when in
use. Prolonged use, higher concentrations of airborne particles
and various other factors may result in the filters needing to be
cleaned more often.
1. Remove the filters by pushing the tabs to release. (Fig. 18)
●
Do not rotate the temperature control knob to the "MAX
COOL" position (as shown above) at night to prevent being
frozen up.
●
When the operating control mode knob is in "COOL" mode
position, always keep at least 2 duct vents open to prevent
being frozen up.
WARNING: The air conditioner could be frozen up when the
ambient temperature is relatively low, e.g. ≤78ºF (25.5ºC).
2. The filter can be washed with warm soapy water. Care
must be taken to avoid ripping the fabric.
3. Replace the filters, decoration plate and control knobs by
reversing the above process.
NOTE: The filter must be completely dry before re-
installation.
To Replace the Filter
Filter changes should be carried out depending on the amount
of use, it is recommended to change at least every 12 months.
Never operate the air conditioning system without a filter, since
this can decrease performance and indoor air quality.
Replacement return air filters can be ordered directly from
Furrion.
- 10 - CCD-0005773 Rev: 04-25-22