Before First Use; Operation - Batavia MAXXBRUSH Mode D'emploi

English
Multimaterial brush: regular maintenance
and cleaning of various materials: stone,
wood, tiles, etc.
The following two brushes are also available
separately:
Steel brush: removing very stubborn dirt,
moss and scale.
Spiral brush (green): Option 1 – suitable as
an artificial grass brush to make your artifi-
cial grass look tidy. With this brush the
fibres are brushed upright again, making
your artificial grass look like new again.
Option 2 – removing stubborn dirt.

5. Before first use

• Remove the device and all additional
parts out of the packaging.
• Check all parts for damage in transit
and do not use a damaged device.
• Keep packaging materials out of reach
of children. There is risk of suffocation!

6. Operation

• Make sure the power mains voltage
corresponds to the operating voltage
stated on the type label.
• Use only suitable extension cords for
outdoor use. Preferably use extension
cords with a cable H07 RN-F; 3 x 1.5
mm . If in doubt, refer to a professional.
2
• We recommend using a residual current
circuit breaker with a nominal residual
current of ≤ 30 mA.
Secure the extension cord one the
6.1
strain relief hook (7) by forming a loop
(See Fig. B).
To switch on the device press the safety
6.2
button (4) first and then press the ON/
OFF trigger (6). Release the safety but-
ton (See Fig. C).
With the speed adjusting wheel (3) you
6.3
can steplessly set the speed of the
brush roller.
Use the multimaterial brush for regular
maintenance and removal of dirt:
– Place the multimaterial brush in the
machine, see chapter: changing the
brush.
– Set the speed control (3) to position 3.
8
– Place the machine on the material to be
cleaned. Switch on the machine by
pressing the safety switch and then the
ON / OFF switch.
– Increase the speed to the desired posi-
tion depending on the material.
Use the steel brush or spiral brush for
removing stubborn dirt:
– Place the steel brush or spiral brush in
the machine, see chapter: changing the
brush.
Note the steel brush is sharp!
Always wear gloves when installing
or removing the steel brush.
– Set the speed control (3) to position 3.
– Place the machine on the material to be
cleaned. Switch on the machine by
pressing the safety switch and then the
ON / OFF switch.
– Increase the speed to the desired posi-
tion depending on the material.
Do not use the steel brush on soft
stones or tiles with imprint, the
steel brush may damage them.
Always test a small, inconspicuous
piece first to check that the steel
brush does not damage the mate-
rial to be cleaned. The steel brush is
suitable for removing stubborn dirt.
On wood the steel brush can also
act as a sanding machine, remov-
ing the top layer of the wood.
Do not use the steel brush for regu-
lar maintenance, use the multi
material brush for this.
Use spiral brush for artificial grass:
Before brushing, it is important to clear the
artificial grass as much as possible from
leaves, twigs, waste, etc. This can be done
with the help of a leaf blower and / or rake.
Never brush the artificial grass when the
artificial grass is wet.
– Make sure the spiral brush is clean.
– Insert the spiral brush into the machine,
see chapter: changing the brush.
– Set the speed switch (3) to position 3.
– Place the machine on the artificial grass
and switch on the machine by pressing
the safety switch and then the ON / OFF
switch.