Table Des Matières - Wavetek Meterman CT-235 Manuel D'utilisation

The CT235 and CT237 Current Clamps are warranted against any defects of
material or workmanship within a period of one (1) year following the date of
purchase of the multimeter by the original purchaser or original user. Any
multimeter claimed to be defective during the warranty period should be
returned with proof of purchase to an authorized Wavetek Meterman Service
Center or to the local Wavetek Meterman dealer or distributor where your
multimeter was purchased. See maintenance section for details. Any implied
warranties arising out of the sale of a Wavetek Meterman multimeter, including
but not limited to implied warranties of merchantability and fitness for a
particular purpose, are limited in duration to the above stated one (1) year
period. Wavetek Meterman shall not be liable for loss of use of the multimeter
or other incidental or consequential damages, expenses, or economical loss or
for any claim or claims for such damage, expenses or economical loss.
Some states do not allow limitations on how long implied warranties last or the
exclusion or limitation of incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
PLEASE READ SECTION 2 - SPECIFICATION BEFORE OPERATING
THE INSTRUMENT
Exceeding the maximum limits of this instrument is DANGEROUS.
Exceeding these limits will expose you to physical injury or even death and will
almost certainly damage your instrument. Even low-level voltages and currents
are capable of causing serious injury or even death.
Please do not use this or any piece ot test equipment without proper training.
Individual functions and ranges have different overload limits. It is VERY
IMPORTANT that you make yourself aware of these overload limits. Check the
specifications of these overload limits.
International Electrical Symbols
Caution! Refer to this manual before using
the probe.
Probe is protected by Reinforced or Double
Insulation.
CONTENTS
Warranty Statement
1 INTRODUCTION
2 SPECIFICATIONS
2.1 Electrical Data
2.2 General Data
3 OPERATING INSTRUCTIONS
3.1 Switch On
3.2 Zero Adjustment
3.3 Current Measurement
4 SAFETY
5 BATTERY REPLACEMENT
6 FACTORY SERVICE
7 FREQUENCY RESPONSE
AND ACCURACY CURVES
1. INTRODUCTION
The CT-235 and the CT-237 current probes have been designed for use with
digital multimeters, recorders and other suitable equipment for accurate non-
intrusive measurement of AC, DC and complex waveform currents.
WARRANTY
WARNINGS AND PRECAUTION
OPERATING INSTRUCTIONS
- 1 -
Page 1
Page 1
Page 2
Page 2
Page 3
Page 3
Page 3
Page 3
Page 3
Page 4
Page 7