Operating Elements And Connections - Monacor International JTS UF-10TB/12 Mode D'emploi

Contents
1

Operating Elements and Connections . 10

2 Important Notes . . . . . . . . . . . . . . . . . . . . 11
3 Applications . . . . . . . . . . . . . . . . . . . . . . . 11
3.1 Conformity and approval . . . . . . . . . . . . . . 11
4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . 11
4.1 Inserting / Replacing the batteries . . . . . . . . 11
4.2 Connecting the microphone
and fastening the transmitter . . . . . . . . . . . 11
4.3 Switching on/off the transmitter . . . . . . . . . 12
4.4 Settings via the menu . . . . . . . . . . . . . . . . 12
4.5 Basic settings . . . . . . . . . . . . . . . . . . . . . . 12
4.6 Setting the transmission frequency . . . . . . 13
4.6.1 REMOSET
4.6.2 Setting the frequency manually . . . . . . . 14
4.6.3 Selecting a frequency from a group . . . . 14
4.7 Adjusting the input sensitivity . . . . . . . . . . 14
4.8 Muting the microphone . . . . . . . . . . . . . . . 14
4.9 Key lock . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
5 Specifications . . . . . . . . . . . . . . . . . . . . . 15
Transmission frequencies . . . . . . . . . . . . . 28
10
® function . . . . . . . . . . . . . . . 13
All operating elements and connections de -
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 Transmitting antenna
2 Battery status LED; shows red when the batter-
ies are discharged
3 LED PEAK / MUTE
shows red in case of overload at the input of the
transmitter
keeps flashing in yellow to indicate that the
microphone connected has been muted with
the button (4)
4 Button to switch on / off and to mute the micro-
phone and to exit a menu
To switch on or to exit a menu,
press the button briefly.
To mute / unmute,
press the button briefly; when the microphone
is muted, the LED MUTE (3) keeps flashing
To switch off,
keep the button pressed for 2 seconds until
the display shows
5 Latch for the battery compartment (6)
6 Battery compartment cover
7 LED REMOSET: lights up for 5 seconds to indi-
cate that the REMOSET function has set the
pocket transmitter to the transmission fre-
quency of the receiver (
8 Microphone connection (4-pole mini XLR jack)
9 Buttons ▼ and ▲ to select a menu item and to
change settings
10 Button SET to call up the setup menu shown in
fig. 2 (keep the button pressed for 2 seconds until
the menu appears on the display), to call up a
menu item and to save a setting (
11 Display, showing:
the name of the unit, any name may be selected
(10 characters)
G = the group number (1 ... 12)
C = the channel number (1 ... 60)
MHz = the transmission frequency
(624.000 ... 694.000 MHz)
. . dB = the microphone sensitivity adjusted
(-18 dB ... 12 dB)
= the battery status
Power OFF
.
chapter 4.6.1)
chapter 4.4)