Charging System; Review Data - EnergyFlo T2 Notice D'utilisation

3.2. Cranking Test
Cranking Test
Start Engine

3.3 Charging System

Charging Test
Loaded Testing
****

3.4 Review Data

Choose the "Review Data" function to review your last test
Health:96%
Charge:98%
Internal R=6.1mΩ
Rated: 500A
GOOD BATTERY
3.5 Print Data
Choose the "Print" function data and press ENTER.
Before choosing the print data function, it is necessary to install the software on your computer and then to connect the Battery
Tester via the USB cable. Once the software is installed, open the Print software and Choose the COM Port NO:
If there are incomplete print tasks in the queue please clear them before proceeding.
You can now print the test results.
Limited Warranty
The warranty of this unit depends on the conditions granted by your retailer. The manufacturer shall have no liability whatsoever
at any time for any warranty, personal injury or property damage. Transport is never included. Please dispose of the packaging in
a responsible manner. It should be recycled by your local amenity or placed in appropriate recycling bins. Never dispose of
electrical equipment or batteries in your domestic waste. Have them recycled by your retailer or your local amenity.
Cranking Test
RPM Detected
Increase RPM to
2500 r/min,
(maintain for 5 seconds)
Press ENTER to continue.
490CCA
12.64V
Charging Test
Testing
****
3
EN
Cranking Test
Time 780ms
Cranking Normal
10.13V
Charging Test
Loaded 14.16V
Unloaded 14.39V
Replace 15mV
Charging Normal