Display Messages; Maintenance And Care; Troubleshooting - Schumacher Electric Schulink SC1366 Manuel D'utilisation

15. DISPLAY MESSAGES

"CONNECT BATTERY"
(Blue LED only, solid*) – Plugged into the
AC outlet without the clamps connected to
a battery.
"WARNING CLAMPS REVERSED"
(Red and Blue LEDs solid*) – Plugged
into the AC outlet and the clamps are
connected backwards to a 6V or 12V
battery.
"CHARGING" (Green LED solid) –
Plugged into the AC outlet, and when
first connected to a 6V or 12V battery
correctly.
"CHARGING 12V XX%"
(Green LED solid) – Plugged into the AC
outlet, correctly connected and charging a
12V battery.
"CHARGING 6V XX%"
Green LED solid) – Plugged into the AC
outlet, correctly connected and charging a
6V battery.
*Blue LED is only lit when connected to a
wireless network.

16. MAINTENANCE AND CARE

A minimal amount of care can keep your
battery charger working properly for years.
• Clean the clamps each time you are
finished charging. Wipe off any battery
fluid that may have come in contact with
the clamps, to prevent corrosion.
• Occasionally cleaning the case of the
charger with a soft cloth will keep the
finish shiny and help prevent corrosion.

17. TROUBLESHOOTING

PROBLEM
The charger's blue
CONNECTED LED is not lit.
The charger will not turn on
when properly connected.
I cannot select a 6V or 12V
setting.
POSSIBLE CAUSE
The charger is not connected
to a wireless network.
AC outlet is dead.
Poor electrical connection.
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
• 12 •
"FULLY CHARGED AUTO MAINTAINING"
(Green LED pulsing) – Plugged into a live
grounded AC outlet and correctly connected
to a fully charged 6V or 12V battery.
"CHARGE ABORTED-BAD BATTERY"
(Red LED solid) – Circumstances that could
cause an Abort situation during charging:
• The battery is severely sulfated or has a
shorted cell and can't reach a full charge.
• The battery is too large or there is a
bank of batteries and it doesn't reach full
charge within a set time period.
Circumstances that could cause an Abort
situation during maintain:
• The battery is severely sulfated or has a
weak cell and will not hold a charge.
• There is a large draw on the battery and
the charger has to supply its maximum
maintain current for a 12 hour period to
keep the battery at full charge.
• Coil the input and output cords neatly
when storing the charger. This will help
prevent accidental damage to the cords
and charger.
• Store the charger unplugged from the AC
power outlet.
• Store inside, in a cool, dry place. Do not
store the clamps clipped together, on or
around metal, or clipped to the cables.
See Section 12.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and
extension cord for loose fitting
plug.
No problem; this is normal.
SOLUTION