Trimming Instructions - Black+Decker BEHT200 Mode D'emploi

Attaching the Bail Handle (FIG. D, E)
1. Cut the plastic zip tie.
2. Remove the 4 screws that are partially run into the
trimmer housing (Fig. D).
Fig. D
3. Slide the bail handle onto the front of the trimmer
housing behind the guard.
4. Insert the four screws into the openings on the side of
the bail handle and tighten securely as shown in Fig. E.
Fig. E
Attaching Extension Cord to Trimmer
(FIG. F)

WARNING:
is not engaged to reduce the risk of starting the
appliance accidentally.
A cord retainer is incorporated into the rear of the handle on
the power head.
1. Near the end of the extension cord, fold the extension
cord to create a loop.
2. Feed the loop into the cord retainer housing
shown in Fig. F.
3. Hook the loop onto the cord retainer
cord retainer.
4. Plug the extension cord into the power head.
Fig. F
Ensure the trigger switch
10 as
7 so it rests in the
7
11
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
OPERATION

WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Proper Hand Position (Fig. G)

WARNING:
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation
of a sudden reaction.
Always hold the trimmer, as shown in the illustrations in
this manual, with one hand on the switch handle and one
hand on the bail handle (Fig. G). Never hold the unit by the
blade guard.
Switch
To turn the tool "ON", slide the lock off button
Fig. G, backward and squeeze the trigger switch
the unit is running, you may release the lock off button.
In order to keep the unit running you must continue
to squeeze the trigger. To turn the tool "OFF", release
the trigger.

WARNING:
switch in the ON position.
Fig. G
4

Trimming Instructions

1. EXTEnsiOn CORD – (Fig. H) – Always keep extension
cord behind trimmer and away from the trimming
operation. Never drape it over a hedge being trimmed.
If you cut or damage the cord, unplug it at the electrical
outlet immediately, before inspecting or repairing cord.
2. WORKing POsiTiOn – Maintain proper footing and
balance and do not overreach. Wear safety goggles,
non-skid footwear and rubber gloves when trimming.
Hold the tool firmly in both hands and turn the tool ON.
English
To reduce the risk of
To reduce the risk of serious
To reduce the risk of serious
4 , shown in
5 . Once
Never attempt to lock a
5
5