Dyna-Glo DGPH101BR Manuel Du Propriétaire page 9

ASSEMBLY INSTRUCTIONS
10. Support heater. Slide three washers Φ8 (GG)
over threaded end of reflector spacer (FF). Position
reflector assembly over three spacers. Install three
washers Φ8 (GG) on reflector spacers (FF) and securely
tighten M8 wing nuts (KK) but do not overtighten.
Hardware Used
GG Washer Φ8
KK
M8 Wing nut
11. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
CONNECTING GAS CYLINDER
Use only 20-pound cylinders (height: 18.11 inches/46CM
tank diameter: 9.84 inches / 25CM, foot diameter: 8.03
inches / 20.4CM) equipped with a cylinder connection
device compatible with the connection for outdoor cooking
appliances. The gas cylinder should not be dropped
or handled roughly!
Minimum Gas Supply Pressure : 5.0 psi / 35 kPa
Maximum Gas Supply Pressure： Bottle pressure
Outlet pressure setting of regulator
is 11.0 in.W.C / 2.74 kPa -LPG.
Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the appliance.
A cylinder must be stored outoors in a well-ventilated area
out of the reach of children.
A disconnected cylinder must have dust caps tightly installed
and must not be stored in a building, garage or any other
enclosed area.
The minimum hourly of 17000Btu/H / 4.98 KW is required
input rating for a heater for automatic operation at ratings
less than full input rating.
The pressure regulator and hose assembly supplied with
the appliance must be used. The installation must conform
with local codes, or in the absence of local codes, with
national fuel gas code, ANSI Z223.1/NFPA54, natural gas
and propane Installation Code, CSA B149.1, or propane
storage and handling code, B149.2.
x 6
x 3
9
10
KK
GG
FF
11