During Periods Of Extended Inactivity Or When Transporting - Dyna-Glo DGPH101BR Manuel Du Propriétaire

CARE AND MAINTENANCE
Signs of possible blockage include:
Gas odor with extreme yellow tipping of flame.
•
Heater does NOT reach the desired temperature.
•
Heater glow is excessively uneven.
•
Heater makes popping noises.
•
Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and
•
render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if
•
any carbon deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.
Frequently check for corroded areas and repair them promptly.
TIP:
Use high-quality automobile wax to help maintain the appearance of your heater. Apply to exterior
surfaces from the pole down. Do not apply to emitter screen or domes.
Storage
Between uses:
Turn off control valve and cylinder valve.
•
Disconnect the hose regulator from propane cylinder.
•
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,
•
sleet, hail, snow, dust and debris).
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
•
Note: Wait until heater is cool before covering.

During periods of extended inactivity or when transporting:

Turn off cylinder valve.
•
Turn Control Knob OFF.
•
Disconnect the hose regulator and move the cylinder to a secure, well ventilated outdoor location.
•
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,
•
sleet, hail, snow, dust and debris).
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
•
Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until heater is cool before covering.
Service
Only a qualified service person should repair gas passages and associated components.
Caution: Always allow heater to cool before attempting service.
16