BENE U-LIFT Instructions D'utilisation page 9

SAFETY INSTRUCTIONS
For the above reasons do not use the control
23
unit: above or below heat sources ( e.g. heaters),
at places exposed to direct sunlight, in small,
unventilated or humid rooms, near easily flamma-
ble materials or near high-frequency devices (e. g.
tranmitters, radiation equipment or similar).
Warning: If a fault occurs, then any attempt
to operate the drive before the safety shutdown
is activated may result in the desktop moving
slightly. Please take care to avoid possible danger
of crushing!
Warning: The collision protection is inactive
during all reset processes. Please take care to
avoid possible danger of crushing!
Please note: If the product is visibly dam-
aged, it must not be installed or used!
After 2 minutes of continuous operation the
24
system automatically shuts itself off and cannot
be used for an additional 18 minutes. This keeps
the motor from overheating.
Do not exceed maximum load
25
of 30 kg.
Do not put your legs between fixed and moving
26
parts to create crushing and shearing points.
9 9