LUND 10780 Instructions De Montage page 2

LIGHT BAR INSTALLATION:
1. Remove light bar from box and screw bolts and washers into each end.
2. Slide bolts into crossbeam brackets with the washers on the outside of the bracket, and tighten using
the supplied allen key.
BULL BAR INSTALLATION:
1. Starting at the driver side, remove the factory tow hook if equipped, (Figures 1A & 1B). NOTE: This
Bull Bar is not compatible with the factory tow hooks and they cannot be reinstalled. IMPORTANT: On
some model years, with and without tow hooks, the pocket in the plastic bumper may need to be
trimmed or completely cut out, (Figure 1A). Use a sharp knife or hacksaw blade and carefully cut out
the pocket to clear the Bull Bar Brackets. Only cut enough to clear the Brackets.
Fig 1A
Driver Side Installation Pictured
Fig 1B) Remove the tow hook and hardware,
(Driver/left tow hook pictured from below bumper)
Page 2 of 12
2011-15 CHEVY SILVERADO/GMC SIERRA 2500/3500
Front
I-Sheet Number 10780
3-1/2" OVAL BULL BAR
12/19/14