Philips dynalite PDUVCC-NA Instructions D'installation page 10

Table des Matières

Publicité

PDUVCC-NA Control solution for UV-C surface disinfection
The site specific installation manual shall include detailed
information for properly locating the components of a system
in a given space. This information shall include, as applicable,
drawings depicting examples of correct installations, as well
as examples of unacceptable installations that may pose
a risk of UV overexposure (e.g. installation at inappropriate
heights, locations or orientations, open sightlines between
the radiation source and exposed upper floors, stairs or
walkways, etc.).
Le manuel d'installation spécifique au site doit inclure des
informations détaillées permettant de localiser correctement
les composants d'un système dans un espace donné. Ces
informations comprennent, le cas échéant, des dessins
illustrant des exemples d'installations correctes, ainsi que des
exemples d'installations inacceptables pouvant présenter
un risque de surexposition aux UV (par exemple, installation
à des hauteurs, des emplacements ou des orientations
inappropriés, lignes de vue ouvertes entre la source de
rayonnement et les étages supérieurs exposés, escaliers ou
passerelles, etc.).
Only install sensors supplied with the system. Ensure that
only the required number of sensors are installed for your
space. The remainder can be used as spares.
Installez uniquement les capteurs fournis avec le système.
Assurez-vous que seul le nombre requis de capteurs est
installé pour votre espace. Le reste peut être utilisé comme
pièces de rechange.
Refer to user guide for system setup and operation.
Reportez-vous au Guide de l'utilisateur pour la configuration
et le fonctionnement du système.
© 2020 Signify Holding. All rights reserved. The information provided
herein is subject to change, without notice. Signify does not give any
representation or warranty as to the accuracy or completeness of
the information included herein and shall not be liable for any action
in reliance thereon. The information presented in this document
is not intended as any commercial offer and does not form part
of any≈quotation or contract, unless otherwise agreed by Signify.
PDUVCC-NA 12/20 philips.com/lighting page 10 of 10
Federal Communications Commission (FCC) Compliance
Notice: Radio Frequency Notice – This equipment has been
tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving
antenna. Increase the separation between the equipment
and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult
the dealer or an experienced radio/TV technician for help. Any
modifications not approved by the manufacturer of this device
could void the user's authority to operate this device.
Aviso de Cumplimiento de la Comisión Federal de
Comunicaciones (Federal Communications Commission; FCC):
Aviso de radiofrecuencia – Este equipo fue probado y se
encontró que cumple con los límites de un dispositivo digital
de CLASE B conforme a la Parte 15 de las reglas de la FCC.
Estos límites están diseñados para brindar una protección
razonable en contra de la interferencia perjudicial en una
instalación doméstica. Este equipo genera, usa y puede
irradiar energía de radiofrecuencia y, si no se instala y utiliza
de acuerdo con las instrucciones, puede causar interferencia
perjudicial a las comunicaciones por radio. Sin embargo, no
se garantiza que no ocurrirá interferencia en una instalación
en particular. Si este equipo causa interferencia perjudicial a
la recepción de radio o televisión, lo cual puede determinarse
encendiendo y apagando el equipo, se le recomienda al
usuario tratar de corregir la interferencia tomando una o más
de las siguientes medidas: volver a orientar o cambiar de lugar
la antena receptora; aumentar la distancia entre el equipo y
el receptor; conectar el equipo en un enchufe en un circuito
diferente al que está conectado el receptor; consultar al
distribuidor o a un técnico de radio/televisión con experiencia
para obtener ayuda. Toda modificación que se realice a este
dispositivo sin la autorización del fabricante podría invalidar la
autoridad del usuario para operar este dispositivo.
This Class B digital apparatus complies with Canadian ICES-
003: CAN ICES-3(B)/NMB-3(B).
Este aparato digital Clase B cumple con el ICES-003
canadiense: CAN IC-ES-3(B)/NMB-3(B).
Signify North America Corporation
200 Franklin Square Drive,
Somerset, NJ 08873
Telephone 855-486-2216
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. All other trademarks
are owned by Signify Holding or their respective owners.
Signify Canada Ltd.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Telephone 800-668-9008

Publicité

Table des Matières
loading

Table des Matières