About Your New Thermostat; Compressor Protection - Honeywell Home RTH2510 Serie Manuel Du Propriétaire

NOTE: If you do not press any button for 60 seconds while you are in the setup
menu, the thermostat automatically saves any changes made and exits the
menu.
Description
Function Press the s or t button to
1 select system type
5 select your heating system
and optimize its operation
13 select Early Start
14 select Fahrenheit or Celsius
temperature display
15* select Compressor
Protection settings
20 select clock display
21 select Change Filter Timer
40 restore program schedule to
default settings
* Compressor Protection: This feature forces the compressor to wait approximately 5 minutes
before restarting, to prevent equipment damage. During the wait time, the message "Cool On" or
"Heat On" is displayed on screen.

About Your New Thermostat

Your new Resideo thermostat has been designed to give you many years of
reliable service and easy-to-use, push-button climate control.
Backlit display is easy to read
•
Displays ambient (measured) temperature at all times
•
One-touch access to setpoint temperature
•
Preset program settings
•
Temporary and permanent override of schedule
•
Early start ensures the right temperature at the right time
•
Built-in compressor protection
•
Setting
0 Heating & cooling: Gas, oil or electric heating with
central air conditioning or heat pump without auxiliary/
back-up heat.
1 Heat pump with auxiliary/backup heat: Outside
compressor provides both heating and cooling.
5 Gas or oil furnace: Use this setting if you have a
standard gas or oil furnace that is less than 90%
efficient.
6 Electric furnace: Use this setting if you have any type
of electric heating system.
3 Heat pump, hot water or high-efficiency furnace:
Use this setting if you have a hot water system or a gas
furnace of greater than 90% efficiency.
2 Gas/oil steam or gravity system: Use this setting if
you have a steam or gravity heat system.
1 On
0 Off
0 Fahrenheit temperature display (°F)
1 Celsius temperature display (°C)
1 On
0 Off
0 12-hour display
1 24-hour display
0 Off
1 30 days
2 90 days
0 Off
1 On: Program schedule default settings are listed on
page 12.
10
3 6 months
4 9 months
5 1 year