Publicité
Les langues disponibles
Les langues disponibles
PARTS LIST:
1
Driver/left Sidebar
1
Passenger/right Sidebar
1
Passenger/right Front Upper Bracket (all incl. DEF)
1
Passenger/right Front Lower Bracket (all incl. DEF)
5
5" Sidebar Brackets (use for left or right)
11
8-1.25mm Clip-On Nuts
Passenger/right front
only Upper Bracket
Passenger/right
Sidebar
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED. ON MODELS
WITH DEF TANK, SELECT A FLAT, LEVEL AREA FOR INSTALLATION.
1. Start the installation under the driver side of the vehicle. Locate the 5 tabs along the bottom edge of the
body, (pinch weld). Mounting Brackets will bolt to the 1st, 2nd, (just in front of center of cab), and 5th
mounting tabs, (Figure 1). Directly above each tab is a top mounting location on the side of the body
panel. Hold a Bracket up in place to help determine the mounting holes to use along the body.
2. Determine the correct procedure for your model year and each Bracket location.
Bottom mounting location on the edge of the pinch weld.
Flat tab on pinch weld with factory installed weld nut:
Thread hex bolt into weld nut from the backside-down to clear paint from threads, (Figure 2).
Flat tab on pinch weld with hole:
Select (1) 8mm Clip Nut. Slide the Clip Nut over the tab with the nut facing up behind the tab,
(Figures 3—5). Line up threaded nut with hole in tab. Repeat for each mounting location.
Top mounting location on the side of the body panel.
Models with factory installed threaded insert in body panel:
Thread 8mm Hex Bolt into threaded insert to clear paint as required, (Figures 2 & 3).
Large and small hole in side of body panel:
Remove the rubber plug from the larger hole, (Figure 4). Select (1) 8mm Clip Nut. Slide the Clip
Nut into the larger hole. Line up the threaded nut with the smaller hole, (Figure 5).
INSTALLATION
I NSTRUCTIONS
PART#
2 3710562/23810562
(5) Left or Right
Mounting Brackets
Passenger/right
front only Lower
Mounting Bracket
25
8-1.25mm x 25mm Hex Bolt
25
8mm x 24mm x 2mm Flat Washer
25
8mm Lock Washer
1
8mm Bolt Plate
1
8mm Nylon Lock Nut (use w-bolt plate)
8mm Bolt Plate
Page 1 of 6
Front
Driver/left
Sidebar
9/2/14 Rev1 (DP)
Publicité
