habitat et jardin Joycy Mode D'emploi page 12

5. Attaches the leg support to the top frame and tightly
secure together with the screws.
7.With stitching portion facing down, lay jumping mat inside
frame and attach a spring into one of the triangle rings on
the mat. The attach the other end of the spring to the
frame.
9.Repeat process for the remaining springs. Use the spring
tool, as shown above.
Warning: During spring assembly, please be careful where
you place your hands other parts of your body as
connector points.
11.Attach the remaining spring until all springs are attached
onto the frame.
2021-2022
6.At this stage the trampoline should like the picture
above.
8. Repeat STEP 7 directly across from where you attach the
first spring. Then attach two more springs half distance
between the first two springs, directly across from each
other. This will ensure equal tension is distributed between
the springs.
10.Spring under heavy tension may require adjacent springs
to be attached at every four or five holes. So the spring
tension is distribute equally.
12. Lay the cover pads on the outer edge so the spring are
covered.
1