Worx WT545 Mode D'emploi page 9

speed (approximately 1 flash per second). Remove the
"dead" battery from the charger and replace with a new
battery.
4) When the charging process is finished, the battery is
still charging with a current 200mA.
Note: The charger timer-circuit and battery pack tem-
perature safety-cutout device prevents overcharging of
the battery pack. However, it is recommended to remove
the battery from the charger when the charging cycle
has been completed as indicated by the illumination of
the green light.
Status
Battery charging
Charger failure
Battery <36ºF (0ºC)
or >122ºF(50ºC)
Battery + 140ºF (60ºC)
Battery + 176ºF (80ºC)
Battery dead
Charging complete
Warning: After extended periods of use, the
battery will become hot. Allow the hot bat-
tery to cool down for at least 1 hour before re-
charging.
3. TO REMOVE OR INSTALL BATTERY PACK
Locate latches on side of battery pack and depress both
sides to release battery pack from your drill. Remove bat-
tery pack from your drill. After recharge insert the battery
pack into drill's battery port. A simple push and slight
pressure will be sufficient.
4. SAFETY ON/OFF SWITCH
Your switch is locked off to prevent accidental starting.
Depress lock off button (B) then on/off switch (A) and re-
lease lock off button (B).Your switch is now on.To switch
off just release the on/off switch (See Fig 2).
The jig saw can be turned ON or OFF by squeezing or
releasing the switch. The speed of the blade can be ad-
justed by the pressure you apply to the switch. To in-
crease the speed, apply more pressure to the switch. To
decrease the speed, apply less pressure.
5. HAND GRIP AREAS
Always ensure you maintain a firm grip while operating
your jigsaw.
Cordless Jigsaw
NA-WT545-M-051115.indd 9
All manuals and user guides at all-guides.com
Light ON/OFF/Flash
red on
red fast flash (5/sec)
green slow flash (1/sec)
green fast flash (5/sec)
red slow flash (1/sec)
red slow flash (1/sec)
green on
Fig 5
Fig 6
Fig 7
Fig 8
WT545
2005-11-15 17:10:37
09