Parts List - Clarke ALTO CTV Manuel D'utilisation

For Squeegee Assembly Installation, Follow this Procedure:
1. Remove head assembly from tank.
2. Turn the handle and tank upside down.
3. Assemble the squeegee and lift frame per parts illustration (see page 36).
4. Install the squeegee lift frame to the tank frame.
5. Turn the handle and tank over to the upright position with the wheels on the floor.
6. Attach the squeegee to the lift frame and tighten the clamping knobs.
7. Attach the straight hose cuff to the squeegee.
8. Replace the head assembly on the tank.
9. Attach other end of the hose to the tank inlet.
10. Adjust the squeegee.
a.) Place the squeegee in the down position.
b.) Place the wrench on the nut (#28) and the screwdriver screwdriver on the head of the screw (#25).
c.) While rolling the machine slightly forward, so the squeegee blade lays over slightly (flares), tighten the
nut (#28).
NOTE: The "L" bracket (#27) is in proper position when the squeegee assembly no longer "plows" into the floor on the
forward push, but still picks up properly on the rear ward pull. Additional adjustments may be required to obtain the
optimum "L" bracket position.
For Squeegee Operation, Follow this Procedure:
1. To raise squeegee, push down on pedal.
2. To lower squeegee, push forward on pedal. The squeegee will operate both forward and backwards.
®
Clarke
CTV 230V Operator's Manual
CTV 7, 15 & 20
Squeegee Assembly (70007035) Parts List 9/04
Ref. Part No. Description
1 27000405 Pedal, Squeegee Lift
2 27000404 Support, Pedal Left
3 27000406 Support, Lift
4 30001508 Hose, Squeegee
5 NA Screw, M6 x 1 x 40 Shoulder Hex
6 27000414 Wheel
7 21448070 Knob
8 27000410 Frame, Squeegee Weldment
9 30292A Blade, Squeegee
10 27000415 Bushing, Wheel
11 27000411 Retainer, Squeegee Blade
12 NA Screw, M5 x 0.8 x 10 Phillips
13 NA Washer, M6.4 x 12.5 x 1.5
14 NA Nut, Lock M6 Lock
15 27000407 Lift, Squeegee Weldment
16 NA Bolt, Shoulder 1/2" x 1.25mm x 22mm
17 NA Washer, M10.5 x 21x 1.5
18 NA Nut, Lock M8
19 27000403 Support, Pedal Right
20 NA Nut, M8 Hex
21 NA Washer, M8.4 x 17 x 1.5
22 NA Washer, Lock M8
23 NA Screw, Hex M8 x 1.25 x 16
24 70007035 Squeegee Assembly (Includes all above)
25 80197A Screw, M8 Hex Head
26 NA Washer, M8 Star
27 61694A Bracket
28 NA Washer, M8 Flat
29 80198A Nut, M8 Lock
NA = Not available.
NOTE: indicates a change has been made since the last publication of
this manual.
Clarke ®
Qty
1
1
1
1
2
2
2
1
2
2
2
18
2
2
1
6
6
6
1
6
6
6
6
1
1
1
1
1
1
Page -37-