LUND 10777 Instructions D'installation page 8

8. Reinstall the splash guard using the factory hardware. Use the included (2) 5mm x 15mm Allen Bolts, (4)
5mm Flat Washers and (2) 5mm Lock Nuts at the ends of the splash guard if required, (Figure 14).
Fig 14
9. Reinstall the Bull Bar described in Step 5, (Figure 10).
10. Level and adjust the Bull Bar and tighten all hardware.
If required, replace the rivet at the corner
of the splash guard with the supplied:
5mm x 15mm Button Head Allen Bolt
(2) 5mm Flat Washers
5mm Nylon Lock Nut
Page 8 of 24
I-Sheet Number 10777
3-1/2" OVAL BULL BAR
09-15 DODGE RAM 1500
12/19/14