LUND 10777 Instructions D'installation page 5

For models with tow hooks:
a. Remove the (2) hex nuts holding the front of the tow hook to the bottom of the bumper bracket,
(Figure 6). Leave the rear hex bolt tight for the moment.
Driver Side Installation Pictured
Front
(Fig 6) Driver side mounting location pictured from
behind bumper on tow hook equipped model
b. Select the driver side Mounting Bracket, (Figure 7). Attach the Mounting Bracket to the (2) tow
hook mounting studs with the (2) factory hex nuts. Do not tighten hardware at this time.
12mm x 35mm Hex Bolt
(2) 12mm Flat Washers
12mm Lock Washer
12mm Hex Nut
(Also attaches the Bull Bar to
the Mounting Bracket)
c. Loosen the rear tow hook bolt. Slide the inner bent end of the driver side Support Bracket between
the bolt and the tow hook or replace with the included (1) 12-1.5mm x 30mm Special Fine Thread
Hex Bolt, (1) 12mm Lock Washer and (1) 12mm Flat Washer, (Figure 7). Do not tighten hardware
at this time.
d. Line up the flat forward end of the Support Bracket with the inside of the Mounting Bracket. The
Support Bracket will attach to the lower rear hole in the Bracket. Do not attach at this time.
3. Repeat the appropriate Step 2 for the passenger side Mounting Bracket installation.
Remove the (2)
factory hex nuts
Front
(Fig 7) Driver side Support Bracket in "with tow
hook" position. Line up Bull Bar Bracket between
Mounting Bracket and Support Bracket
Page 5 of 24
I-Sheet Number 10777
3-1/2" OVAL BULL BAR
09-15 DODGE RAM 1500
12/19/14