LUND 10777 Instructions D'installation page 2

LIGHT BAR INSTALLATION:
1. Remove light bar from box and screw bolts and washers into each end.
2. Slide bolts into crossbeam brackets with the washers on the outside of the bracket, and tighten using
the supplied allen key.
BULL BAR INSTALLATION:
1. Start installation under the front bumper and carefully remove the plastic splash guard. NOTE: Depending
on the model of truck, the splash guard may be attached to the bottom of the truck with hex bolts and
several two-piece plastic push-in clips, (Figure 1A). Remove all hex bolts then locate the clips behind the
bumper cover. Pry up on the center pin of the clip with a small flat blade screwdriver and remove the entire
clip, (Figure 1B). Pay close attention to the type and location of all factory hardware for reinstallation.
IMPORTANT: The splash guard may also be attached at the ends of the bumper cover with rivets. Use
wire cutters to remove the rivets. Once all fasteners have been removed, move the splash guard to a clean
stable work area.
Pry up the center pin to
remove the complete fastener
(Fig 1A) Pictured from behind bumper
Driver Side Installation Pictured
Page 2 of 24
Pin
Housing
Fig 1B
I-Sheet Number 10777
3-1/2" OVAL BULL BAR
09-15 DODGE RAM 1500
12/19/14