Before Calling For Service; Operating Condition - Sharp AH-XP18MV Mode D'emploi

BEFORE CALLING FOR SERVICE
The following conditions do not denote
equipment malfunctions
UNIT DOES NOT OPERATE
The unit will not operate if it is turned on im-
mediately after it is turned off. The unit will
not operate immediately after the mode is
changed. This is to protect the unit. Wait  min-
utes before operating the unit.
ODORS
Carpet and furniture odors that entered into the
unit may be sent out from the unit.
CRACKING NOISE
This sound is generated by the friction of the
unit expanding or connecting due to a tempera-
ture change.
A LOW BUZZING NOISE
This is a sound of the unit generating Plasma-
cluster ions.
SWISHING NOISE
The soft, swishing noise is the sound of the
refrigerant flowing inside the unit.
MIST SEEN AT INDOOR AIR OUTLET
In cooling operation, this is caused by the dif-
ference between the room air temperature and
the air discharged.
THE OUTDOOR UNIT DOES NOT STOP
After stopping the operation, the outdoor unit
will rotate its' fan for about a minute to cool
down the unit.
ODOR EMITTED FROM THE
PLASMACLUSTER AIR OUTLET
This is the smell of ozone generated from
the Plasmacluster Ion generator. The ozone
concentration is very small, posing no adverse
effect on your health. The ozone discharged
into the air rapidly decomposes, and its density
in the room will not increase.
AH-XP18MV_EN.indd 12
All manuals and user guides at all-guides.com
EN-
Check the following points before calling for
service.
The unit does not operate
• Check if the circuit breaker has tripped or the
fuse has blown.
The unit does not cool effectively
• Check the filters. If dirty, clean them.
• Check the outdoor unit to make sure nothing
is blocking the air inlet or outlet.
• Check the thermostat is proper setting.
• Make sure windows and doors are closed
tightly.
The unit does not receive the remote
control signal
• Check whether the remote control batteries
have become old and weak.
• Try to send the signal again with the remote
control pointed properly towards the unit's
signal receiver window.
• Check whether the remote control batteries
are installed properly.
Please call for service when OPERATION
lamp and TIMER lamp on the unit blink.
OPERATING CONDITION
Mode
Upper limit
Cooling
Lower limit
• The built-in safety device may prevent the unit
from operating when used out of this range.
• Condensation may form on the air outlet if the
unit operates continuously in the COOL or
DRY mode when humidity is over 80 %.
Indoor Outdoor
Temp. Temp.
32˚C 43˚C
21˚C 21˚C
11.5.23 11:21:16 AM