Hathaway RENEGADE II Instructions D'assemblage page 4

THANK YOU! ASSEMBLY INSTRUCTIONS
1. Begin LEG assembly by attaching LEG BASE #11 and LEG TOP #12 to one LEG SIDE #10 using 1-3/4" SCREW
#8. Attach one LEG PANEL #9 with 3/4"SCREW #7. Attach remaining LEG SIDE #10 with 1-3/4" SCREW #8.
Attach other LEG PANEL #9 using 3/4" SCREW #7. Repeat assembly for remaining LEG.
2. Attach each assembled LEG to the bottom of the TABLE BODY #5 with BOLT #2 and FLAT WASHER #3.
3. Thread two LEG LEVELERS #1 into bottom of each LEG.
NOTE: Two adults are required to turn table upright.
Turn over using main table body only, NOT legs,
and place on all four feet on ground at same time.
NOTE: Once table is completely assembled and placed
in desired location, use level (not included) to adjust leg
levelers so table is level in both directions.
4