Care And Storage - Beurer BS 59 Mode D'emploi

chargeable batteries.
• Leaking batteries may damage the device. If you do not intend to use the device for longer peri-
ods, remove the batteries from the battery compartment.
CAUTION: Disposal
For environmental reasons, do not dispose of the device in the household waste at the end
of its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of
the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equip-
ment). If you have any questions, please contact the local authorities responsible for waste disposal.
The empty, completely flat batteries must be disposed of through specially designated collection
boxes, recycling points or electronics retailers. You are legally required to dispose of the
batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
3. Operation
• If present, pull the battery insulating strip off the battery compartment cover or remove the
battery's protective film and insert the battery according to the polarity.
• The batteries are located in the mirror. Turn the normal side of the mirror anti-clockwise and re-
move the cover from the mirror. Then open the battery compartment lid. Now you can remove the
plastic insulating strip or change the batteries.
• Check the device for damage.
• The standard side or the magnified side of the mirror can be used. Simply rotate the mirror to the
required side. The light can be switched on and off with the button in the base.
Wall fastening:
• To secure on the wall, the screws on the front of the wall bracket must first be removed.
• Now remove the wall bracket and attach it to the wall using the assembly kit provided (4 screws,
4 wall plugs).
• First mark the desired position on the wall and drill 4 holes at the appropriate intervals.
• Insert the wall plugs. Then attach the wall bracket, by screwing the screws into the wall plugs.
• Now attach the mirror to the wall by fixing the screws to the front of the wall bracket.
• If necessary, you can remove the mirror from the wall bracket by turning the screw on the stand.
Retain this (ideally attach the screw to the wall bracket immediately) so that the mirror can be at-
tached to the wall bracket again if desired.

4. Care and storage

• Switch off the device each time before cleaning.
• First unplug the device and allow it to cool off. Then you can clean it with a soft, slightly moistened
cloth. Then wipe it dry with a soft, lint-free cloth.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or hard brushes.
8