Temperature Unit - Auriol 4-LD4868 Utilisation Et Avertissements De Sécurite

Masquer les pouces Voir aussi pour 4-LD4868:

Utilisation et avertissements de sécurite (54 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Mounting the outdoor sensor

All manuals and user guides at all-guides.com

Two different mounting options are possible with the included sensor mount 42

surface or mounted on a wall or ceiling.

Illustration A

Illustration A shows the three indentations that are on each side of the sensor. The sensor can easily be clipped into the

Illustration A

mount using these indentations.

Illustration B is a side view, which shows how the mount is attached behind the sensor.

Illustration B

Illustration C shows a front view of the sensor with the mount used as a ceiling mount.

Illustration C

Illustration D

Illustration D shows a front view of the sensor with the mount used as a stand.

Illustration D

Illustration E

Illustration E shows the controls and the battery compartment on the backside of the sensor.

Illustration E

Please note: Always hang or stand the sensor upright.

Please note:

Setup

Insert batteries into the outdoor sensor 40 first and then insert batteries into the weather

station 34.

Remove the protective film from the weather station and the outdoor sensor. Open the battery compartment of the

outdoor sensor 40 and insert the included batteries in the correct polarity. The LED indicator 36 will briefly light up and

the display will show the temperature. Close the battery compartment.

Open the battery compartment of the weather station 34 and insert the included batteries in the correct polarity. Close

the battery compartment. The weather symbol 1 1 1 1 blinks and the weather station receives the signal from the outdoor

sensor. This process may take several minutes to complete. If reception is successful, the selected channel 22 and the

current outdoor temperature 24 will appear. After successful reception of the signal for the outdoor sensor, the

reception of the DCF77 time signal will begin and the radio control indicator 18 will blink on the display next to the

time. All buttons except the SNOOZE / LIGHT button 12 are disabled during the reception process. If reception fails

after 10 minutes, please set the time manually. The weather station will reattempt reception at 04:00 and 05:00 and, if

reception is successful, will correct the set time.

Note: Please do not move the weather station or the sensor during the reception process.

If the reception attempt is successful, the radio control indicator 18 will appear permanently on the display and the

correct time, date, day of the week and the times of sunrise, sunset, moonrise and moonset will be set automatically.

DST will appear on the display next to the radio control indicator 18 during daylight saving time.

Time zone adjustment

If you are in a country, in which the clock displays the wrong time even though it can receive the time signal, please use

the time zone adjustment to use your weather station in a time zone other than the standard time zone (UTC+1 =

Central European Time). Set the difference in hours (- 01 for example) to the desired time zone.

In normal time display mode, press and hold the MODE

-button 11 or the +/12/24 -button 14. Press the MODE-button 15, to confirm your setting.

set by pressing the -/

Restart radio reception after changing this setting. Your weather station receives the DCF77 time signal but will show the

adjusted time (1 hour less for example).

Note: Always hang or place the sensor in an upright orientation.

Reception problems

The DCF77 radio signal is transmitted from a location near Frankfurt am Main and can be received within a radius of

approximately 1500 km around Frankfurt am Main. However, there are some obstacles and sources of interference,

which may substantially hinder reception. If your weather station does not correctly receive the DCF77 radio signal,

please hang or place the weather station in a different location at your site. Please note that devices such as computers,

telephones, radios and televisions may cause electromagnetic radiation which can interfere with the DCF77 signal

reception. Other possible detriments to reception are: strong building insulation (metal building materials), nearby

mountains or atmospheric interference. It may also be necessary to replace the batteries.

Restarting radio signal reception

Manually restart the radio signal reception by pressing and holding the -/ -button 11 for 3 seconds.

Light

Briefly activate the backlight by pressing the SNOOZE/LIGHT-button 12.

12/24-hour time format

Select the 12- or 24 hour time format by pressing the +/12/24 -button 14. AM will appear on the display in the

morning, PM in the afternoon if the 12-hour time format is selected.