Connecting To The Mains Power Supply - Pfeiffer Vacuum CENTERONE Instructions D'installation

Installation
1.3

Connecting to the mains power supply

6
Thermal overload!
 Set up the unit so that the admissible maximum ambient temperature (e. g. due to
installation or sunlight) is not exceeded.
 Ensure adequate air circulation!
 Stick the two supplied rubber feet to the rear part of the bottom plate.
 Slip the supplied rubber bar onto the bottom edge of the front panel.
The CenterOne/CenterTwo/CenterThree is equipped with an universal power supply
with an input voltage range of 100 ... 240 V AC.
Excess voltage!
Danger of destroying the unit.
 Power connections must comply with local regulations. Voltage information given on
the rating plate must correspond to the mains voltage values.
 Use only cable with protective earth conductor.
 To protect the electronics and the power supply cable in case of failure provide an
appropriate network safety device.
Danger of electric shock
In case of defect, the parts connected to the mains supply are under voltage.
 Always keep the mains connection freely accessible so you can disconnect it at any
time.
NOTICE
CAUTION
WARNING