Pfeiffer Vacuum CENTERONE Instructions D'installation page 4

Installation
4
Rack mounting at mounting height 2 (applies to CenterOne/CenterTwo/Cen-
terThree)
Thermal overload!
 When setting up the device, ensure that the maximum permissible ambient temper-
ature (due to installation or solar radiation, for instance) is not exceeded.
 Ensure that there is good air circulation!
Accessories for mounting the CenterOne
An adapter plate inclusive of two neck screws and a plastic nipple are available for the
installation of the CenterOne(see accessories).
 Secure the rack module adapter in place in the switchgear cabinet
 only for CenterOne: Fasten the adapter plate in place as an upper extension of the
device front panel using the screws supplied with the adapter plate.
 Slide the device into the rack module adapter.
 Secure the device in place using the screws supplied with the device.
Fig. 3: CenterOne: Insert the adapter plate, slide in the device and fasten it in place
Fig. 4: CenterTwo / CenterThree: Slide in the device and fasten it in place
NOTICE
NOTICE