Continuous Drainage; Cleaning And Maintenance; Cleaning The Housing; Cleaning The Filters - Rowenta RWAC1200H Mode D'emploi

If you wish to operate the appliance with no need to empty the water tank, please:
• Remove the drain cap and rubber plug and retain for future use.
• Connect one end of the drain tube supplied to the bottom drainage point and locate the other end into a drain.

Continuous drainage

When you need operating this appliance in high humidity, during the dehumidification,
cooling or heating mode, connect the drain tube to this appliance.
• Remove the drain cap from the upper or middle drainage point.
The middle drainage point can only be used during heating mode.
• Connect one end of the drain tube onto the drainage point and
extend with extra water tube (not supplied) if needed.
• Place the other end of the drain tube in a normal drain. Make sure
that the tube is free from twists and bends.
NOTE: The drain must be at or below the outlet level.

CLEANING AND MAINTENANCE

Switch off and unplug the appliance from the mains socket before cleaning.
To maximise the efficiency of the appliance clean it regularly.

Cleaning the housing

Clean the housing with a slight damp cloth.
Never use chemical or abrasive cleaning agents.

Cleaning the filters

• The air conditioner is equipped with two filter to remove dust particles:
A filter in the upper air inlet.
A filter in the lower air inlet.
• Remove the upper grille and then take out the upper filter which is behind the grille.
• Loosen a screw on the lower grille and then remove the lower filter.
• The filter should be cleaned regularly. Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt
from the filter and then rinse thoroughly under running water. Dry thoroughly before replacing.
NOTE: Never use the air conditioner without the filter.
Storage
• Drain all water in the appliance before completely
operating the appliance on fan mode for a few hours,
to thoroughly dry the inside of the appliance.
• Clean the filter.
• Wrap the power cord and then insert the power plug
into the power plug sockets at the rear of the appliance.
• Remove the batteries from the remote control.
• Place the appliance in a dry place.
UPPER FILTER
REMOVE THE SCREW, THEN TAKE
THE LOWER FILTER OUT.
EN
POWER PLUG SOCKETS
18