Connecting To External Devices - Avigilon 1.0W-H3PTZ-DP20 Guide D'installation

Connecting to External Devices

External devices, including audio and video devices, are connected to
the camera through the I/O cable. The pinout for the I/O connector is
shown in the following table.
Table: External I/O Connector
Pin Wire Color
1 White
2 Brown
3 Green
4 Yellow
5 Grey
6 Pink
7 Blue
8 Light Red
9 Orange
10 Dark Red
11 Black
12 Purple
The camera can be connected to an external microphone, speaker
and video monitor through the I/O connector.
NOTE: The camera only supports line level mono audio input and an
NTSC or PAL video output.
The video output signal is determined by the camera flicker control
setting. When the camera flicker control is set to 60 Hz, the video
output signal is NTSC. When the flicker control is set to 50 Hz, the
video output signal is PAL. Use the Avigilon Camera Installation Tool
to configure the camera's flicker control in the Image and Display
setup.
All manuals and user guides at all-guides.com
Audio/video analog ground return
Analog audio input
Analog audio output
Analog video output
Relay ground return
Relay output 1
Relay output 2
Relay input 1
Relay input 2
+12 V output for relay drive
Not connected
Description
11