SCHOLTES SH09DLTAB Mode D'emploi page 19

6- Set the cooking time by acting on the SLIDER control
(D1)
Booster (fig.2 - (S)):
Depending on the appliance model, it may be fitted with a
Booster system which can be used to speed up cooking
times through the application of a power level which is
greater than the nominal value, within a defined period of
time. The cooking zones which can be used in conjunction
with this function are indicated in P fig. 2 - C.
To activate the Booster, switch the interested cooking area
on at any power level and press key S (fig. 2). This allows
to reach higher temperatures in a short time disbursing the
maximum power possible. Once the function is activated a
red LED and a P will appear on the display for ten minutes.
After this time the cooking area will automatically return
to power level 9.
Attention!
- If your appliance has two zone cooking (P) using the
Booster function, these can be activated simultane-
ously.
- When the Booster function is active and the lower or
upper vertical cooking zone is to be switched on or is
already on (F1 or F2 - Fig.2) for the duration period of
the Booster and if maximum level is set, the power will
decrease slightly.
- The Booster may not activate if, the cooking zone (with
the letter P) has been previously activated with high tem-
perature levels.
- In order to use the Booster function, wait for the P on
the display R to stop flashing and the temperature inside
the cooking surface to decrease.
Heat up (fig.2 - (L1)) (Rapid heating)
The Heat up function can be used to set the cooking
zone to its maximum temperature for a specified period
of time, after which the temperature will return to a lower
value set previously.
To activate the Heat up function, select one of the
cooking zones (E).
Set the cooking level at "9" by acting on the SLIDER
control (D1), press Heat up (L1)and the cooking zone
will show the letter "A". This means that the (Heat up)
function is active.
Set the desired cooking level (between 1 and 8); the
cooking zone display will now show the letter "A" and
the desired cooking level (e.g. 6) alternately.
- If no cooking level variation is made, the indicator (D2)
switches off.
Note: it is possible ONLY to increase the previously-set
cooking level:
1- Select the cooking zone (E) where the Heat up
function is active.
2- Increase the desired temperature by running your finger
over the SLIDER control (D1).
All manuals and user guides at all-guides.com
When the Heat up function has finished running, the hob
will emit a sound signal or BEEP; the relevant cooking
zone will continue to operate and the cooking level set
previously, e.g. 6.
Maintenance (fig.5)
Remove any residues of food and drops of grease from
the cooking surface using the special scraper supplied
on request .
Clean the heated area as thoroughly as possible using
SIDOL, STAHLFIX or similar products and a cloth/paper,
then rinse with water and dry with a clean cloth.
Using the special scraper (optional) immediately remove
any fragments of aluminium and plastic material that have
unintentionally melted on the heated cooking area or resi-
dues of sugar or food with a high sugar content. In this way,
any damage to the cooktop surface is prevented.
Under no circumstances use abrasive sponges or irritat-
ing chemical detergents such as oven sprays or stain
removers.
THE MANUFACTURER DECLINES ALL RESPONSIBIL-
ITY FOR EVENTUAL DAMAGES CAUSED BY BREACH-
ING THE ABOVE WARNINGS.
GB
19