GreenWorks Commercial GN 220 Manuel Du Propriétaire page 24

All manuals and user guides at all-guides.com
MAINTENANCE
REPLACING THE DIRVE BELT (See Figure 11)
W A R N I N G
Make sure to turn off the bail lever and remove the battery pack(s) before performing any
maintenance task on your snow thrower.
• Remove the screws (1) on the drive belt cover (2).
• Turn the auger pulley (3) counterclockwise while you remove the remaining belt (4).
• Turn the new belt onto the pulleys.
• Install and tighten the screws that you removed.
1
2
4
3
Fig. 11
23