Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Blade Assembly.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 12 blade attachment screws and washers in
hardware pack. Slide a blade through one of the
narrow, rectangular openings on motor housing,
aligning holes in blade with holes in blade arm
(located on INSIDE of the underside of the motor
housing)--refer to drawing at right. Insert 3 blade
attachment screws (along with washers) and then
tighten screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Remove three screws from outer edge of light kit
fitter. Save these screws to secure glass shade later on.
Remove 1 screw from fitter plate on underside of
motor and partially loosen the other 2 screws.
Connect BLACK wire from motor housing to
BLACK wire from light kit fitter. Connect WHITE
wire from motor housing to WHITE wire from light
kit fitter. Be sure that molex connections snap
together completely.
Carefully arrange wiring and safety cable within the
fitter plate. Align slotted holes in the light kit fitter
with loosened screws in fitter plate--be careful not
to pinch wires, molex connections or safety cable
between the light kit fitter and the fitter plate. Twist
light kit fitter to lock. Re-insert screw that was
previously removed. Tighten all 3 screws with a
Phillips screwdriver.
["Light Kit Assembly" continued on next page.]
All manuals and user guides at all-guides.com
page 7
blade
arm
blade
blade attachment
screws and washers
motor housing
motor housing
fitter plate
molex
connections
molex
connections
light kit fitter
Publicité
Table des Matières
