Connecting To Devices Which Control The Projector - JVC DLA-M5000LE Manuel D'instructions

Connecting to Devices which Control the Projector

Before connection, be sure to turn off both the projector and devices to be connected.
• Read the manual thoroughly which comes with each device to be connected.
• By connecting a computer to the RS-232C terminal, you can control the projector.
* For details, consult an authorized your dealer or service center.
• If you connect the cable terminal of the remote control and the REMOTE terminal of the projector with a remote control
cable, you can use the remote control in a place or at an angle from which the infrared beam cannot reach the projector.
• Desktop type
• Note type
• Remote control (when remote control cable is used)
To RS-232C connector
RS-232C reverse
connection cable
(available separately)
To RS-232C connector
To RS-232C connector
To remote control
cable terminal
Connecting to Various Devices
RGB RGB IN-1
R RGB IN-2
G H/C
S
B V
REMOTE
RGB OUT
RS-232C
To REMOTE terminal
Remote control cable
Y/C VIDEO
EXT. IN
Y
P /B-Y
B
P /R-Y
R
CONTROL
21