Before First Use - Krups XP56 Serie Mode D'emploi

KR_ESPRESSO_XP56_8080012290_XXXXXXXX 28/06/13 13:39 Page14

5. BEFORE FIRST USE

Before using your espresso machine, clean all the accessories in warm water and a little washing-up liquid
and dry them.
If you are not using the Claris cartridge, please refer to the paragraph here below "RINSING OF YOUR
APPLIANCE".
A. INSTALLING THE CLARIS CARTRIDGE (to be done every time the cartridge is replaced)
If you are using a Claris filter cartridge, please follow the procedure to fill it with water:
n Screw the Claris filter into the bottom of the water tank.
n Fill the water tank with water and replace it (fig.2 and 3).
n Turn the appliance on by pressing the "On / Off" button (fig.4).
n Turn the switch to the "preheating" position. Once the light stops blinking, turn back the switch to the
"off" position.
n Repeat this operation 2 more times.
n To make sure the Claris cartridge is full of water, place a container under the brewing head, turn the
switch to the "coffee" position and make sure some water is running through. If not, repeat the above
procedure.
n In this manner you can be sure that water is circulating well through the filter cartridge.
IMPORTANT:
This installation procedure must be carried out every time the cartridge is replaced.
The Claris cartridge needs to be replaced every 2 to 3 months if it is used daily.
B. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning / descaling
operation)
- RINSING OUT THE ESPRESSO CIRCUIT
Then rinse the appliance. To do so:
n Open the lid and remove the water tank using the handle (fig.1).
n Fill it with water (fig. 2).
n Replace the water tank by positioning it firmly, to ensure the water inlet is in place, and close the lid
(fig.3).
n Turn the appliance on by pressing the "On / Off" button (fig.4).
n Insert the filter holder (without ground coffee) in the appliance (fig.7).
n Place a container of sufficient volume under the filter holder.
n Once the appliance has reached the right temperature, the light stops blinking. Turn the switch to the
"coffee" position and let all the water in the tank run through.
n If necessary, stop the operation by turning the switch to the "off" position to empty the container and
then resume the operation.
n Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and turn
it to the left (fig.10).
- RINSING OF THE EASY CAPPUCCINO ACCESSORY CIRCUIT
Before first use of the cappuccino accessory, it is necessary to clean the circuit.
n Fill water tank.
n Turn the appliance on by pressing the
n Place a container under the accessory.
n Turn the switch to the
All manuals and user guides at all-guides.com
button.
position, the button starts to flash.
English
14