Dyna-Glo DGB730SNB Mode D'emploi page 8

Step 7: Preassemble cart front vertical beam (8) and upper front door
brace (11) as "T" shape by using two M6x12 screws (A).
Hardware/Parts Used
A M6x12 Screw
Step 8: Preassemble cart front vertical beam (8) and upper front door
brace (11) as "T" shape assembly. Insert two M6x12 screws (A)
into each of the top mounting holes (labeled as AA) on the cart
left side panel and cart right side panel (13 & 5), leaving 4-6mm
clearance from screw head to the cart left side panel and cart
right side panel (13 & 5). Attach the Cart front vertical beam (8)
and upper front door brace (11) assembly by placing the key
holes over the inserted screw head (A) on the side panels
(13 & 5), slide the upper front door brace (11) so that the screw
head is over the smaller hole. Secure the screws, but do not
tighten completely this time. Secure another two M6x12 screws
into holes (labeled as BB). Finally, secure the cart front vertical
beam (8) to bottom shelf (labeled as CC) by using two M6x12
screws (A).
Hardware Used
A M6x12 Screw
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Qty: 2 pcs
Qty: 6 pcs
11
7
11
A
8
8
13
5
AA
BB
CC
A
8
1