Dyna-Glo DGB730SNB Mode D'emploi page 13

Step 14: Carefully place Gas grill lid assembly (31) and charcoal grill lid
assembly (32) onto the gas grill and charcoal firebox
separately. Insert 1 Lid pivot pin A -left & right HH into the hole
in left side panel of gas grill firebox through the left mounting
hole on the left of gas grill lid assembly (31); Insert 1 Lid pivot
pin A - left & right (H) into the hole in right side panel of char
coal grill firebox through the right mounting hole on the right of
charcoal grill lid assembly (32); Insert 1 Lid pivot pin B- Middle
II into the hole in the right side of gas grill firebox through the
hold in the right of gas grill lid assembly (31), the hole in the
left of charcoal grill lid assembly (32), and the hole in the left of
charcoal grill firebox. Note: lift the grill gas lid assembly (31)
and charcoal grill lid assembly (32) while inserting the Lid pivot
pins, make sure the holes are in position.
Secure Lid pivot pin A - reft & right (H) and Lid pivot pin B -
Middle II with 3 cap nuts (J)and 3 plain washers (B).
Hardware Used
H Lid Pivot Pin A
I Lid Pivot Pin B
J Cap Nut
B M6 Plain Washer
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Qty: 2 pcs
Qty: 1 pcs
Qty: 3 pcs
Qty: 3 pcs
16
14
31
H
31
32
I
B
J
32
H