Publicité
WARNING
Risk of Electric Shock, Fire, and Injury. Review the Assembly Instructions to confirm that the appropriate critical
components and accessories are being used with this stand.
The power bar is a critical component: the supplied power bar must be a 6 outlet power bar, identified as
Model TPL615B. This model number is molded into the cover on the bottom of the power bar. This is the only
approved power bar for this unit.
The wall bracket, WM-SBID-200 (Model W200-1), is a critical component. It is required for use with the SBID-6000S
and SBID-7000R series displays. This is the only approved mounting bracket for use with this unit.
AVERTISSEMENT
Risque de choc électrique, d'incendie et de blessure. Consultez les instructions de assemblage pour confirmer
que les composants et accessoires critiques appropriés sont utilisés avec ce stand.
La barre d'alimentation est un composant critique - la barre d'alimentation fournie doit être une barre d'alimentation
à 6 prises, identifiée comme le modèle TPL615B. Ce numéro de modèle est moulé dans le couvercle au bas de la
barre d'alimentation. Il s'agit de la seule barre d'alimentation approuvée pour cet unite.
Le support mural WM-SBID-200 (modèle W200-1) est un composant critique. Il est nécessaire pour une utilisation
avec les écrans des séries SBID-6000S et SBID-7000R. Il s'agit du seul support de montage approuvé à utiliser
avec cet unite.
FCC
Suppliers Declaration of Conformity 47 CFR § 2.1077 Compliance Information • Unique Identifier: S410-2 or S420-2.
Responsible Party – U.S. Contact Information: SMART Technologies Inc. 2401 Fourth Ave., Suite 300, Seattle, WA 98121
Mail to: compliance@smarttech.com
FCC Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with ICES-003 of the ISED rules. Operation is
subject to the following
wo conditions:
t
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
support.smarttech.com/support
support.smarttech.com/contact-support
© 2020 SMART Technologies ULC. All rights reserved. SMART Board, smarttech, the SMART logo and all SMART taglines are trademarks or
registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. All third-party products and company names may be
trademarks of their respective owners. Contents are subject to change without notice. This product and/or use thereof covered by one or more of
the following U.S. patents; smarttech.com/patents. Other patents pending. Aug 10, 2020
Innovation, Science and Economic Development Canada (ISED)
Cet appareil est conforme à la norme ISED NBM-003 pour les appareils
radio agréés. Son fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage
susceptible de provoquer un fonctionnement indésirable.
smarttech.com/kb/171619
Publicité
