Dometic GROUP Waeco MagicComfort MSH100 Instructions De Montage Et De Service page 23

_MSH100.book Seite 23 Montag, 6. September 2010 6:37 18
MagicComfort MSH100
Installing the heating element for the backrest
NOTICE!
A
If the seats are equipped with side airbags, then there is a prede-
termined breaking point in the cover fabric. The seat cover must
therefore not be pulled tightly or slip out of place.
➤ Open the lower area of the backrest cover (fig. d, page 4).
➤ Push the heating element into the gap between the seat cover and the
seat cushion (fig. e, page 4).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
Installing the seat
➤ Reassemble the backrest and seat.
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
Electrical connection
The complete circuit diagram can be found in fig. h, page 5.
NOTICE!
A
Ensure it has been securely fitted, particularly in the area of the
seat rails.
➤ Attach the switchbox to a suitable location in the vicinity of the dashboard
(fig. i, page 6).
➤ Find a suitable place for installing the seat heater switch.
If possible, use the blanking plugs provided for this purpose.
Ensure that there is enough room behind the panel for the installation of
the switch.
➤ Mark the switch cut-out using the template provided (fig. j, page 6).
➤ Cut out the marked area with an appropriate tool.
➤ Install the switch into the cut-out (fig. f, page 4).
➤ Install the ready-made wiring harness so that the cables cannot bend or
fray (fig. g, page 4).
All manuals and user guides at all-guides.com
Installing the seat heater
23