Technical Data; Intended Use; Safety Points - TREND PH/JIG/C Traduction Des Instructions Originales

EN - TWIN POCKET HOLE JIG
Dear Customer,
Thank you for purchasing this Trend product, which should give lasting performance if used in
accordance with these instructions.

TECHNICAL DATA

Material thickness: Min. 12.7mm
Max. 38mm
Material width: Min. 38mm
Screw Length:
Drill bit size:
Hole pitch:
The following symbols are used throughout this manual.
Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance
of the instructions.
Refer to the instruction manual of your power tool.
This unit must not be put into service until it has been established that the power tool to be connected
to this unit is in compliance with 2006/42/EC (identified by the CE marking on the power tool), or for
the UK, The Supply of Machinery (Safety) Regulations 2008 (identified by the UKCA mark).

INTENDED USE

This accessory is to be used with a drill with minimum 10mm chuck capacity to allow pocket hole
jointing of softwoods and hardwoods.
SAFETY
Please read and understand the safety points in these instructions as well as you power tool
instructions.
PLEASE KEEP THESE INSTRUCTIONS IN A SAFE PLACE

Safety Points

1. Disconnect power tool attachment from power supply when not in use, before servicing, when
making adjustments and when changing accessories such as cutters. Ensure switch is in "off"
position and cutter has stopped rotating.
2. Read and understand instructions supplied with power tool, attachment and cutter.
3. Current Personal Protective Equipment (PPE) for eye, ear and respiratory protection must be
worn. Keep hands, hair and clothes clear of the cutter.
4. Before each use check cutter is sharp and free from damage. Do not use if cutter is dull, broken
or cracked or if any damage is noticeable or suspected.
5. The maximum speed (nmax) marked on tool or in instructions or on packaging shall not be
exceeded. Where stated, the speed range should be adhered to.
6. Check all fixing and fastening nuts, bolts and screws on power tool, attachment and cutting tools
PH/JIG/C
25mm-63mm
9.5mm
21.5mm
- 3 -