Koenic KFZ 45221 A2 NF Mode D'emploi page 19

Caution
• Pull out the mains plug!
• The mounting should be performed by at
least 2 persons to avoid dangerous.
Pull off the top cover. If necessary use a
1
plastic card or spatula to loosen the cap.
Disconnect the plugs and sockets.
2
During unscrewing hold the refrigerator door
3
or it might be damaged. Remove the three
screws of the top hinge.
Pull out the door and place it on a soft and
4
clean surface.
Remove the blind cap on the top of the
5
freezer (use a plastic card or spatula to help
loosen the cap) and insert it into the holes
on the right side.
Pull off the strip at the top of the door and
6
place the cable to the other side as shown.
Make sure the cable is placed correctly and
7
clip back the strip to the upper side of the
door.
Remove the hinge part with the door stop
8
at the bottom of the door. Take the supplied
new hinge part with door stop and fix it to
the other side of the door. Make sure that
the hinge part is correctly seated in the
designated recess.
Loosen the two screws on the lower hinge
9
plate and remove it. If necessary tilt the
refrigerator to get better access to the
bottom side.
Unscrew hinge pin and foot, screw them in
10
again on the opposite side.
Remove the two caps and the screw on the
11
left side. Attach the screw and caps on the
right side.
Position the hinge plate on the left side so
12
that holes and tapped holes are aligned.
Tighten the hinge plate properly.
Place the door on the lower hinge pin.
13
Keep the door in position. Take the
14
additional upper hinge provided and insert
the hinge pin into the corresponding hole in
the upper side of the door. Hold the hinge
plate in position and screw it on.
IM_KFZ45221-A2-NF_190315_V06_HR.indb 19
All manuals and user guides at all-guides.com
Remove the switch from the right-hand cap
15
and insert it into the supplied left-hand cap.
Connect the plugs and sockets. With the
door open, attach the supplied left cover
cap to the hinge so that it snaps into place
at all corners and edges, and fix it to the
refrigerator with the screw. Make sure that
you do not damage the cables.
Installing the door handle
Remove the two blind plugs at the desired
16
side of the door.
Screw on the handle with provided screws.
17
Clip the two provided caps onto the screws.
18
Caution
After you have placed the freezer upright
on its feet, wait for 24 hours before you
connect it to the mains to permit the cooling
system to regain full capacity.
Energy saving tips
• Do not place the product in the vicinity of a
heat source (radiator or kitchen stove, etc.).
• Ensure unobstructed air flow around the
refrigerator and freezer.
• If an ice layer has built, defrost the unit. A
thick ice layer affects the transmission of the
cold, thus the energy consumption will be
increased.
• When opening and taking out food, only
open the door shortly. A shorter door
opening time causes less ice to deposit on
the freezer walls.
• Select the temperature regulator setting
according to the filling amount of the
product.
• Use drawers, baskets or shelves to store the
food. If the energy of the product is used
efficiently, the energy consumption can be
minimized.
English
19
15/3/2019 11:12