Attaching The Drive Assembly For Tilt-Head Mixers - KitchenAid KSMICM Manuel D'utilisation

PRODUCT USAGE

ATTACHING THE DRIVE ASSEMBLY FOR TILT-HEAD MIXERS

1
Be sure the Stand Mixer is OFF (0) and
unplugged. Keep the motor head tilted
back and put the Dasher and Freeze Bowl
into place.
3
Lower the motor head to engage the
Drive Assembly with the Dasher. If the
Drive Assembly doesn't engage the
Dasher, slide the Drive Assembly either
back or forward until it does engage the
Dasher properly.
5
Place locking lever in the LOCK position.
Before mixing, test the lock by attempting
to raise the motor head.
2
Place Drive Assembly onto the mixer,
aligning the cutout with the mixer shaft.
4
Make sure the motor head is down
completely.
5