Installation - Klarstein MAXIWAVE Mode D'emploi

INSTALLATION

• Make sure that all the packing materials are removed from the inside of the door.
• WARNING: Check the oven for any damage, such as misaligned or bent door,
damaged door seals and sealing surface, broken or loose door hinges and latches
and dents inside the cavity or on the door. If there is any damage, do not operate
the oven and contact qualified service personnel.
• This microwave oven must be placed on a flat, stable surface to hold its weight and
the heaviest food likely to be cooked in the oven.
• Do not place the oven where heat, moisture, or high humidity are generated, or
near combustible materials.
• For correct operation, the oven must have sufficient airflow. Allow 20cm of space
above the oven, 10cm at back and 5cm at both sides. Do not cover or block any
openings on the appliance. Do not remove feet.
• Do not operate the oven without glass tray, roller support, and shaft in their proper
positions.
• Make sure that the power supply cord is undamaged and does not run under the
oven or over any hot or sharp surface.
• The socket must be readily accessible so that it can be easily unplugged in an
emergency.
• Do not use the oven outdoors.
Radio interference
Operation of the microwave oven can cause interference to your radio, TV, or similar
equipment. When there is interference, it may be reduced or eliminated by taking the
following measures:
1. Clean door and sealing surface of the oven.
2. Reorient the receiving antenna of radio or television.
3. Relocate the microwave oven with respect to the receiver.
4. Move the microwave oven away from the receiver.
5. Plug the microwave oven into a different outlet so that microwave oven and
receiver are on different branch circuits.
EN
23